Filter
Top Products
Cardio Theater Integrated Bracket Assembly Instructions
page 13
6
Reinstall the Bracket Cover
Reinstall the
Bracket Cover
1. Prepare the fasteners for reinstalling the bracket
cover.
Push the washers and bearings toward the bolt
heads so there is room for the bracket cover to
slide in flush against the pivot tube.
Important: Keep the bracket cover flanges flush
with the pivot tube. The washers and bearings
need to remain on the outside of the bracket
flanges.
2. Hold the bracket cover above the pivot tube.
Apply pressure to the top of the bracket cover
while you slide it into position.
3. Tighten the two top screws on the back of the
LCD Screen.
Use a Phillips-head screwdriver to fully
tighten the top two screws on the back of
the LCD Screen. Access holes have been
drilled through the bracket cover.
4. Secure the bracket cover.
Using a torque wrench and a ⁷⁄₃₂-inch hex key,
retighten the two pivot tube fasteners to 120 in-lbs.
1
Bracket
cover
2
4
3
Top of bracket cover
Bracket cover
Pivot tube
Pivot tube