Filter
Top Products
Assembling the EFX 23
To attach the handlebars:
Important: Attach one handlebar at a time.
1. Use a ³₁₆-inch hex wrench to loosen the two screws in the
handlebar clamp. Refer to the following illustration for the
location of these fasteners.
Figure 14: Clamp screw location, EFX handlebar bracket
2. Connect the heart rate cable from the console to the heart
rate cable from the handlebars and place excess cable
inside the handlebar.
Figure 15: Threading of the heart rate cable
Important: Do not stretch, crimp, or damage the cable.
Cables damaged by improper installation will not be covered
by the Precor Limited Warranty.
3. Insert the right handlebar into the handlebar clamp until
the foam grip touches the side of the handlebar clamp.