Filter
Top Products
14 Assembling and Maintaining Elliptical Fitness Crosstrainers: EFX 883 / 833
Begin installation of all fasteners by hand, then partially
tighten them. Do not fully tighten fasteners until
instructed to do so.
Important: When wrench-tightening the screws, make sure
the head of the fastener is parallel to the product surface. If it
is not, stop tightening to avoid cross-threading. To avoid
further damage, stop assembly work and contact Customer
Support.
Installation Requirements
Prior to assembly, make sure you have the required tools and
hardware.
Hardware Kit (not to scale)
The hardware kit shipped with this equipment contains the
fasteners and other hardware components shown in the
following table. Before you begin assembly, make sure that
your hardware kit is complete. If not, please contact Precor
Customer Support.
Fasteners
Quantity
Flat washers (⁵₁₆-inch) 14
Split washers (⁵₁₆-inch) 14
Flat head hex drive screws
(¹₄-inch x ³₄-inch)
4
Phillips-head machine screws
(#8 x ³₄-inch)
3
Buttonhead screws (⁵₁₆–inch x �
1� –inch)
14