Filter
Top Products
Assembling the AMT 23
To thread new cables through the equipment:
1. Select the console power cable (red and black, individual
leads), the Ethernet cable (flat and black), or the
television cable (round and black).
2. Thread the cable through the center column at the front
of the equipment.
3. Guide the end of the cable through the gap at the bottom
of the center column, then attach it to the appropriate
connector on the jack panel. Refer to the following
illustration and table for the position of each connector.
Connect … To …
The console power
cable
The power cable assembly
The Ethernet cable The eight-connector modular jack on the
jack panel
The television cable The coaxial connector on the jack panel
4. Repeat steps 1 through 3 until all three cables are
completely installed.
5. Insert all cables into the cable clips on the center frame
pillar just below the bottom of the center column. Use
plastic ties to bind the cables together below the clips and
to route them away from any moving parts.