Filter
Top Products
22 Assembling and Maintaining Adaptive Motion Trainers: AMT 885 /835
Removing Access Covers
With its access covers removed, the AMT provides easy
access to its cables and internal components.
Tip: In the following procedure, set aside the covers and their
mounting hardware in groups, in the order in which you
remove them. This simplifies reinstallation later.
To remove the access covers:
1. Using a rubber mallet or the heel of your hand, tap at an
upward angle against the side of the top column cover to
snap it loose.
Figure 6: Where to place pressure when removing top cover
2. Lift the cover, then slide it toward the rear of the
equipment and out.
3. Using a ⁵₃₂” hex wrench, disconnect the two 1-inch
buttonhead screws at the bottom of the front cover, then
snap the cover loose.
Threading the Cables
Depending on the model of console you are installing and the
options it includes, you will need to install one or more of the
following cables:
Television (coaxial with F connectors)
Power
Ethernet
Precor recommends threading new cables from the top down,
to take advantage of gravity. A fish tape (a thin metal strip
with a hook or clasp on one end, available from professional
hardware vendors) can be helpful during this procedure.