Filter
Top Products
Ab-X100 Assembly Guide
page 9
Assemble the Main Structure
1. Insert the End Caps (M) into the Front Support and
attach two plastic feet (L) to its base. Secure the
pieces using
two 1¼-inch buttonhead screws (G)
two split washers (E)
Wrench tighten.
2. Set the Main Frame in an upright position.
3. Cut the wire tie holding the Support Bar to the
wheeled Base Support and remove any packing
material.
4. Attach the Base Support to the Main Frame. Ask
your assistant to lift the Main Base while you align
the mounting holes and insert
four 1-inch buttonhead screws (A)
four split washers (B)
four flat washers (C)
Wrench tighten.
Note: Make sure the wheels are positioned as
shown in the illustration. The wheels must be
outside of the Main Frame not under it.
5. Loosen the four screws that secure the mounting
bracket so you can install the Handlebar Assembly.
Assemble the Main Structure
Main Frame
Base Support
4 - 1" buttonhead screws
4 - split washers
4 - washers
Main Frame
Front Support
2 - 1¼" buttonhead screws
2 - split washers
End Cap
Loosen the four bracket
screws two full turns.
Support Bar