Filter
Top Products
Ab-X100 Assembly Guide
page 11
11. Install the Back Pad Channel Support onto the
Linkage Block using
four ¾-inch buttonhead screws (D)
four split washers (E)
Wrench tighten.
12. Lift and pull back on the Support Bar so you can
align the Back Pad Channel Support with the Pivot
Tube side mounts. Secure the Back Pad Channel
Support to the Pivot Tube using
four ¾-inch buttonhead screws (D)
four split washers (E)
Wrench tighten.
13. Slide the Footrest into the Main Frame and secure
it using
two 1-inch buttonhead screws (A)
two split washers (B)
two washers (C)
Wrench tighten.
Main Frame
Support Bar
Assemble the Main Structure, continued
Footrest
Back Pad
Channel
Support
Linkage
Block
4 - ¾" buttonhead screws
4 - split washers
4 - ¾" buttonhead screws
4 - split washers
2 - 1" buttonhead screws
2 - split washers
2 - washers
Pivot
Tube