Filter
Top Products
User’s Reference Manual: Display Console 9
More Information about the
Center Display
The program profile appears during an exercise session in the center
portion of the display. Your heart rate appears if you are using the
chest strap. Refer to Heart Rate Features.
During a workout, the program profile raises or lowers according to
which arrow key (▲ or ▼) is pressed. In most programs, the program
profile is affected by the RESISTANCE arrow keys with the exception
of the Basic HRC Program. The column height changes according to
the settings shown in Diagram 4.
Diagram 4: Column height in the program profile
During an exercise session, the display becomes a message bar
showing additional information depending on user selections and
program interludes.
More Information about the
Lower Display
The lower display provides information about your workout session.
You can choose the type of information displayed in Column 1 and
Column 3 by pressing the adjacent Selection key. The numbers that
appear over each column of information relate to your workout
statistics and are described below.
Note: If you choose to rest a book or magazine on the display, you can
still view these workout statistics.
Column 1: TIME ELAPSED and TIME REMAINING
TIME ELAPSED—displays workout time in minutes and seconds and
indicates the amount of time you have been exercising. When you
exceed 60 minutes during a single workout, the TIME ELAPSED
display converts to hours and minutes.
Note: The club can place limits on workout time.
TIME REMAINING—shows the amount of time remaining in a
workout. If the selected workout time is less than 60 minutes, the
display shows time in minutes and seconds. If you select a workout
time greater than 60 minutes, the display reflects hours and minutes
until the countdown reaches 60 minutes, at which time the display
reverts to minutes and seconds.
CALORIES—indicates the estimated cumulative number of calories
being burned.
1 — 2
3 — 4
5 — 6
7 — 10
11 — 14
15 — 19
20 — 25
Column height
Resistance settings