Filter
Top Products
1.
AHach the Leg Press Frame to the Main Frame
on lop using two {2) l~"x 41~" Bolts,
two (2) 1/2" Washers, two (2) I/2" Lockwashers
and two (2) 1,~,, nuts.
2.
Attach four (4) 4" x17" Non-Skid Strips to the
angled foot pl~e on the Leg Press Frame as
shown.
3. Install two (2) 2" Square End Caps {10-14 ga)
into the angled tubes on the Leg Press Frame
and two (2) 2" Square End Caps
(10-14 ga)into the base tubes of the
Leg Press Frame.
4.
Slide one (1) Weight Stock Cushion over the
Pin Stop of the base of the Leg Press Frame.
---~
V:’x4V2"BOLT-2 ~
b"2
~
WASHER - 2 PL
b~" LOCK WASHER - 2 PL
~,,’2" NUT - 2 PL
2" SQ. END CAP - 2 PL
j
NON-SKID ,~" X 17" - 4 PL
WEIGHT STACK CUSHION
2" SQ. END CAP-2 ~"~
1.Attach the Leg Press Frame to the Main Frame
al lhe base using two (2) ~’8" x 41~" Bolts,
two (2} ~" ~kwasher~ and two (2)
~hers.
~" LOCKWASHER - 2 PL