Filter
Top Products
If you have installed a second weight stack, go to
Figure 5.
If you have not purchased the second weight
stack, please camp]ere the folJowing steps before
proceeding to F~gure 5.
1.Remove the blank shroud from the rear of the
Factor 625.
2. Remove the rotary cable from the unit and
also the assadated shock cord.
3. Load the Leg Press Cable into the
D-Ring in the position the Rotary Cable was
removed from. Remove the elastic shock cord
from the Rotary Cable and attach to the Leg
Press Cable as shown (same routing of elastic
cord as on Rotary Cable).
ELASTIC SHOCK CORD
LEG PRESS CABLE
(PB3236-01)
-- D:RING
1. Attach two (2) 4V2 w/l Clev;s Pulleys to the
t
’~ ’--:~ ~ --~’-
Base Frame and one {I) mare long cable
retaining clip with existing hardware after
removing one (1) 41/2" w/2" Clevis Pulley
previously installed. (See Detail "A"). Route
~
cable as shown. The pulley at the right side (as ~k~.
LEG PRESS C.ABLE
you face the back of the unit) has Leg Press
FRO,~ D-RING
cable from D-ring routed under and back up to
pulley shown in Figure 2.
PULLEY-2 PL
LONG
R~AINING CUP-2 PL
. PULL~ -2 PL
SIDE VIEW