Filter
Top Products
897101 WEIGHT STACK OPTION ASSEMBLY INSTRUCTIONS;
o
Remove the ].AT BAR from the HIGH PULLEY CABLE, and set aside. Loosen and re,hove the three (3)
3-1/2 X 1 IN PULLEYS from the TOP BOOM WELDMENT of the PROSYSTEM. Detach HIGH
PULLEY CAl3LE from the WEIGHT CARRIAGE WELDMENT, remove the CABLE.
Loosen and remove TOP BOOM WELDMENT from the PROSYSTEM. Then Remove the WEIGHT
CARRIAGE WELDMENT from the PROSYSTEM.
Remove the 2 IN SQ END CAPS from the top and bottom of the UPRIGI-/T FRAME WELI)MENT of the
PROSYSTEM.
Insert four (4i) 2 IN SQ END CAPS into the ends of the BASE WELDMENT as shown on drawing.
Loosen the night bolt connection of the BASE to the UPRIGHT FRAME WELDMENT on the.
PROSYSTE~I and remove nut. SECURELY assemble the BASE WELDMENT to the ~?RIGHT
FRAME WELDMENT of the PROSYSTEM as shown, using the replacement 1/2 IN LOW I-IEIGHT
LOCK NUT.
Insert the GU-IDE RODS into the holes of the BASE WELDMENT as shown, and allow them to tilt
back. (NOTE: LUBRICATE GUIDE RODS WITH A SILICON OR TEFLON SPRA]0. Slide the
two (2) WEIGHT STACK CUSHIONS down over the GUIDE RODS as shown.
SECURELY assemble the WEIGHT STACK SHAFT to the HEAD PLATE as shown oa drawing.
Also insert two (2) WEIGHT PLATE BUSHINGS each into twenty (20) WEIGHT PLATES as shown
(DETAH~ A).
USING EXTREME CARE slide the WEIGHT PLATES down over the GUIDE ROILS onto the
WEIGHT STACK CUSI-HONS as shown. (MAKE SURE THAT THE KEY HOLES OF THE
WEIGHT PLATES ARE ALL FACING AS SHOWN) Slide the HEAD PLATE ASSEMBLY down
over the GUIDE RODS onto the WEIGHT STACK as shown.
Part Number 6660001
3
12/30./96