Filter
Top Products
BLOCK
4-1/2" PULLEY,~
~
"’~~3/8X2"
~UPRIGHTFRAME
3/8X2-3/4"
FIGURE 10
STEP 10:
¯ Route the end of the 134-3/4" CABLE (10) through the slot of the UPRIGHT FRAME then SECURELY assemble one previ-
ously removed 4-1/2" PULLEY to the UPRIGHT FRAME using two previously removed 3/8 X 2-3/4" BOLTS, two 3/8"
FLANGE SPACERS, two 3/8" WASHERS, and two 3/8" LOCK NUTS. (NOTE: The CABLE (10) s]aould be routed between
the pulley and the retaining bolt as shown in FIGURE 10.)
¯
Wrap the CABLE (10) aorund one 3-1/2" PULLEY (8) and SECURELY assemble the PULLEY to the: plate on the UPRIGHT
FRAME using one 3/8 X 2" BOLT (14), one CABLE RETAINING CLIP (13), one 3/8" WASHER (17), and one 3/8"
NUT (18). (NOTE: Before tightening PULLEY, make sure RETAINING CLIP is positioned as shown in FIGURE 10.)
¯ WRAP the CABLE (10) around the bottom 3-1/2" PULLEY of the PULLEY BLOCK asshown in FIGURE 10.
1/2 I
1/2 I 1/2 1
1/2 I 1/2 I 1/2
6
4
I I ~._1
1
I I I II I I I
10