Filter
Top Products
893102 PROSYSTEM ASSEMBLY INSTRUCTIONS
Assemble the appropriate END CAY~S to the UPRIGHT FRAME WELDMENT..BENT TUBE. and the
LOW ROWATTACHMENT WELDMENT as shown, also attach the 5-1/2 X 2-1/2 IN. NON SKID
STRIPS to the LOWROWATTACHMENT as shown.
SECURELY assemble the LOW ROWATTACHMENT WELDMENT and the UPRIGHT FRAME
~VELDJ~IENT to the BENT TUBE as shown.
LOOSELY assemble the UPRIGHT WELDMENTS to the BENT TUBE as shown.
Attach eight (8) 1 IN. SQ. GLIDES to the CARRIAGE WELDMENT as shown in (DETAIL A) also
attach the 1-1/4 SQ. RUBBER BUMPER to the CARRIAGE WELDMENT as shown, then proceed to
slide the CARRIAGE WELDMENT down over the UPRIGHT FRAME WELDMENT as shown..
Attach the 1-1/2 X 3/4 IN. GLIDES. and the THUiV~SCREWS to the SAFETYRAIL WELDMENTS as
shown in (DETAIL B), also assembie two (2) SPRING PIN ASSEMBLIES to the SAFETY RAIL
WELDMENTS as shown in (DETAIL D), then proceed to slide the SAFETYRAIL WELDMENTS down
over the UPRIGHT WELDMENTS as shown.
TOP BOOM WELD~’~IENT PRE-ASSEMBL Y:
A.
Route CABLE (6576201) through the front slot and down te the rear slot of the TOP BOOM
WELDkIENT.
B.
LOOSELY assemble three (3) 3-1/2 X 1 IN. PULLEYS with FLANGE SPACERS to the TO_...__P
BOOM ~VELDMENTas shown. (NOTE: MAKE SURE CABLE IS IN THE GROOVE OF
THE PULLEYS)
C.
Assemble the 3 X 2 IN. END CAP to the TOPBOOM WELDMENT as shown.
D.
When the TOP BOOM WELDMENT PRE-ASSEMBL Y is complete, LOOSELY assemble it to
the UPRIGHT FRAME WELDMENT as shown.
4
12/06/95