Filter
Top Products
8
STEP 3:
FIGURE 3
• CAREFULLY slide one GUIDE ROD (9) through the upper hole in the LEFT and RIGHT UPRIGHT FRAMES (8 &12). Slide
one 1” SHAFT COLLAR (11) over the bottom of the GUIDE ROD (9), as shown in FIGURE 3.
10
5
6
11
9
12
• Hook the SMITH BAR (5) onto slots of the BAR SUPPORT RACKS (10).
8
• CAREFULLY lower the GUIDE ROD (9) through the HOUSING (6) on the SMITH BAR (5). (NOTE: Allow the GUIDE RODS
(9) to push plastic tube out the bottom of the HOUSING (6). Discard this tube)
• Insert the GUIDE ROD (9) into the bottom hole of the LEFT and RIGHT UPRIGHTS (8 &12). Repeat these steps on opposite
side.
• Slide the 1” SHAFT COLLARS (11) up the GUIDE RODS (9) to the bushing and SECURELY TIGHTEN.