Filter
Top Products
837101 WEIGHT STACK ATTACHMENT ASSEMBLY INSTRUCTIONS
USING EXTREME CARE slide the WEIGHT PLATES down over the GUIDE RODS onto the
WEIGHT STACK CUSHIONS as shown. (MAKE SURE THAT THE KEY HOLES OF THE
WEIGHT PLATES ARE ALL FACING THE SAME WAY) Slide the HEAD PLATE ASSEMBLY
down over the GUIDE RODS onto the WEIGHT STACK as shown.
I0.
Tilt the GUIDE RODS back up underneath the PULLEY HOUSING WELDMENT and insert the 3/8 X
2 IN. NYLON BOLTS through the PULLEY HOUSING WELDMENT and into the ends of the GUIDE
RODS as shown in (VIEW B)
11. .Loosen and remove the top PULLEY from the PULLEY BLOCK and replace it wi.th the 4-I/2 X 1 IN.
PULLEY.
12..
SECURELY assemble the remaining PULLEY from the BOOM WELDMENT, and the swapped
PULLEY of the PULLEY BLOCK to the PULLEY HOUSING WELDMENT as shown in (VIEW B).
13. HIGH PULLEY CABLE ROUTING ASSEMBLY (SEE CABLE ROUTING DL4GRAM):
Ao
Uo
Co
Route the end of the CABLE under, and around the 4-1/2 X 1 IN. PULLEY of the PULLEY
BLOCK, and back up through the BOOM WELDMENTto the large hole of the PULLEY
HOUSING WELDMENT.
Route the CABLE through the hole and over and around the two PULLF, YS inthe PULLEY
HOUSING WELDMENT. Run the cable down through the large hole above the WEIGHT
STACK and do~vn to the WEIGHT STACK SHAFT of the HEAD PLATE.
Thread the end of the CABLE into the end of the WEIGHT STACK SHAFT.
Insert the 3 X 2 IN. END CAPS into the ends of the PULLEY HOUSING WELDMENT as
shown in (VIEW B).
14.
Re:attach LA T BAR WELDMENT to the HIGH PULLEY CABLE.
15. Attach the WEIGHT STACK LABELS to the WEIGHT STACK as shown in (DETAIL C).
16.
To select WEIGHT, rotate the WEIGHT STACK SELECTOR PIN clock wise 90 degrees, insert into the
slot of the desired WEIGHT PLATE, and rotate the PIN back down.
4
12/01/95