ParaBody 837101 Fitness Equipment User Manual


 
837101 WEIGHT STACK ATTACHMENT ASSEMBLY INSTRUCTIONS
Remove LIT BAR WELDMENT from the HIGH PULLEY CABLE, and set aside. Loosen and remove the
three (3) 3-1/2 X 1 IN. PULLEYS from the BOOM WELDMENT. Detach HIGH PULLEY CABLE from
the CARRL4GE WELDMENT and remove.
Loosen and remove BOOM WELDMENT from the FRONT and REAR UPRIGHT WELDMENT. Remove
the 2 IN. SQ. END CAP from the top of the REAR UPRIGHT WELDMENT. Remove the CARRIAGE
WELDMENT from the REAR UPRIGHT WELDMENT.
Insert the 1-3/4 SO. X 18-1/4 IN. TUBE into the top of the REAR UPRIGHT WP_ZDMENT as shown in
(VIEW B), then SECURELY re-assemble the BOOM WELDMENT to the R,EAR UPRIGHT
WELDMENT as shown.
Route CABLE (6577701) through the front slot and down to the rear slot of the BOOM WELDMENT. Re-
assemble two (2) of the three (3) 3-1/2 X 1 IN. PULLEYS to BOOMWELDMENTas shownon the
(CABLE ROUTING DIAGRAM). (NOTE: MAKE SURE CABLE IS THEGROOVE OF T HE
PULLEYS). SECURELY re-assemble the BOOM WELDMENT to the FRONT UPRIGHT WELD3tENT.
SECURELY assemble the PULLEY HOUSING WELDMENT to the 1-3/4 SO. X 18-1/4 IN. TUBE as
shoxvn in (VIEW B)
Slide one (1) 2 IN. SQ. COVER CAP over the end of the WEIGHT STACK BASE WELDMENT, then
SECURELY assemble it to the BASE WELDMENTas shown in (VIEW A) (NOTE: THE
PULLEY CABLE MUST BE ASSEMBLED EXACTLY THE WAY SHOWN TO ENSURE
PROPER FUNCTION)
Insert the GUIDE RODS into the holes of the WEIGHT STACK BASE WELD?~4ENT as shown, and
allow them to tilt back. (NOTE: LUBRICATE GUIDE RODS WITH A SILICON OR TEFLON
SPRAY THAT IS AVAILABLE AT MOST HARDWAR~ STORES). Slide two (2) WEIGHT
STACK CUSHIONS down over the GUIDE RODS as shown.
o
SECURELY assemble the WEIGHT STACK SHAFT to the HEAD PLATE as .,;hown on drawing. Also
insert the WEIGHT PLATE BUSHINGS into the WEIGHT PLATES as shown in (DETAIL C).
3
12/01/95