Filter
Top Products
~1/2 X 5"
_LLL
_LLLL
LLLLLLLLLLLLLL
_LLLLLLLLLLLLLLLLL
.LLLLLLLLLLLLLLLLLLLLLLLL
LLLLLLLLLLLLLLLLLLLLL
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
.LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL[
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
_LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL[
_LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
L
LLLLLLLLLLLLLLLLLLLLLLLLLL
LLLLLLLLLLLLLLLLL
LLLLLLLLLLLLLLLL
_LLLLLLLLL
L
FIGURE 2
STEP 2:
¯
Insert four 1/2" FLANGE BEARINGS (46) into the BUSHINGS on the BASE (1), and four 1/2" FLANGE BEARINGS (46)
the BUSHINGS on the PLATFORM (11) as shown in FIGURE
¯ Assemble the PLATFORM (11) between the BUSHINGS on the BASE (1) as shown in FIGURE 2 using two 1/2 X 5" BOLT’3
" T
andtwo 1/2 LOCKNU S (33). (TIGHTEN THE CONNECTION ENOUGH TO REMOVE THE PLAY, YET ALLOWING
THE PLATFORM TO ROTATE FREELY)
STEP 3:
¯
Attach four 1-1/2 X 3/4" PARAGLIDE STRIPS (27) to the end
the PLATFORM ADJUSTMENT (12), and four 1-1/2 X 3/4"
PARAGLIDE STRIPS (27) to the end of the PLATFORM SLEEVE
as shown in FIGURE 3 using the following steps:
¯ Thoroughly clean all surfaces where the PARAGLIDE
STRIPS (27) are to be attached.
¯
Remove the PARAGLIDE STRIPS (27) from the paper
backing and firmly apply them to all shown surfaces.
SECURELY Assemble one 1/2" DIA. SPRING PIN (47) to the
SPRING PIN HOUSING, on the PLATFORM SLEEVE (2)
showninFIGURE 3. (!!! IMPORTANT !!! TIGHTEN THE
NUT OF THE SPRING PIN SECURELY)
FIGURE 3