Filter
Top Products
827102 LAT MACHINE ASSEMBLY INSTRUCTIONS
NOTE: BOLT LENGTH IS MEASURED FROM THE UNDERSIDE OF THE HEAD OF THE BOLT.
BOLT LENGTH
BOLT LENGTH RULER:
1/2 I 1/2 I 1/2 [ 1/2 I 1/2 1 1/2
1 2 3 4 5 6
2.
3.
4.
Insert One (1) 2" END CAP and two (2) 2-1/2" OD END CAPS into the open ends of the BASE.
Apply two (2) 2-1/2" X 5-t/2" NON SKID STRIPS to the BASE as shown on drawing,
Insert two (2) 2" END CAPS into the open ends of the FRONT UPRIGHT,
Insert one (1) 3 X 2" END CAP into front end &the BOOM and slide two (2) 3/8 ID X 5" VINYL
CAPS over fat bar hooks.
Insert one (1) 2" END CAP into the top of the REAR UPRIGHT, Install two t12) 2" COVER CAPS over
bottom ends of the REAR UPRIGHT.
Assemble two (2) 4 X 7" ROLLER PADS to the FRONT UPRIGHT using one (1) ROLLER PAD SHAFT and
two (2) MUSHROOM CAPS,
3
12120/95