Filter
Top Products
4
PARTS LIST
PART #
6416402
6416302
6125101
6406501
6194601
3102910
KEY
1
2
3
4
5
6
QTY
1
1
2
1
6
1
PART #
3102502
3102804
6020601
3105401
6236701
3104301
DESCRIPTION QTY
2
1
2
6
4
1
DESCRIPTION
LEG EXTENSION
LEG EXTENSION NECK
ROLLER PAD SHAFT
U-PIN
ROLLER PAD
1/2 X 3” BOLT
KEY
7
8
9
10
11
12
1/2” FLAT WASHER
1/2” LOW HEIGHT LOCK NUT
1/2” FLANGE BEARING
3/4” STAR LOCK
1-3/4” SQ. END CAP
3/4” SQ. RUBBER BUMPER
* Insert one 1-3/4” END CAP (11) into the top of the LET EXTENSION NECK (2).
11
3
1
8
4
REFER TO FIGURE 1 WHILE READING ASSEMBLY INSTRUCTIONS
FIGURE 1
PIN STOP
U-PIN
UPRIGHT TUBE,
BENCH FRAME
6
9
7
5
10
12
* Slide two ROLLER PADS (5) over each end of the shaft on the LEG EXTENSION NECK (2)
and hold in place using two STARLOCK COLLARS (10)
* Insert three 1-3/4” END CAP (11) into the ends of the LEG EXTENSION (1)
* Insert two 1/2” FLANGE BEARING (9) into the bushing on the LEG EXTENSION (1)
* Assemble the LEG EXTENSION NECK (2) to the LEG EXTENSION (1) using one 1/2 X 3” BOLT (6),
two 1/2” FLAT WASHERS (7) and one 1/2” LOCK NUT (8). (TIGHTEN THE CONNECTION ENOUGH
TO REMOVE THE PLAY, YET ALLOWING THE LEG EXTENSION TO ROTATE FREELY)
* Assemble four ROLLER PAD (5) to the LET EXTENSION (1) using two ROLLER PAD SHAFT (3) and four
STARLOCK COLLAR (10)
* Attach one 3/4” RUBBER BUMPER (12) to the LEG EXTENSION (1) approximately as shown
DETAIL A
2