Filter
Top Products
6
STEP 3:
• Snap two 3 X 2” GUIDE INSERTS (15) into the ends of the WOLFF SLEEVE (7) as shown in FIGURE 3.
0
1
2
345
6
1/2 1/2 1/2 1/2 1/2 1/2
FIGURE 3
• Slide the WOLFF SLEEVE (7) over the BENCH FRAME (3).
• Securely assemble the 2 SQ. X 18” TUBE (8) to the BENCH FRAME (3) using two 3/8 X 3” BOLTS (19), four
3/8” FLAT WASHERS (23), and two 3/8” NYLOCK NUTS (25). See FIGURE 3.
• Securely assemble the BENCH FRAME (3) to the REAR LEG (1) & the SWIVEL PLATE (2) using two 1/2 X
3” BOLTS (21), two 1/2” FLAT WASHERS (24), and two 1/2” NYLOCK NUTS (26) as shown in FIGURE 3.
21 1/2 X 3”
7
3
3/8 X 3” 19
23
8
17
2
26
1
15
23
25
24
• Insert 3/8” SPRING PIN ASSEMBLY (11) into the spring pin barrel on WOLFF SLEEVE (7) and tighten nut
securely. See FIGURE 3.
• Slide one 4” VINYL CAP (17) over the U-PIN (16) as shown in FIGURE 3.
• Slide U-PIN (16) through the bushing on WOLFF SLEEVE (7) and attach with E-RING (27)
16
11
27