Filter
Top Products
,705102 REGGIE WHITE ALL PRO GYM ASSEMBLY INSTR_[UCTIONS
20.
SECURELY assemble two PULLEYS to 5-1/4
PLATE as shown on drawing using two 3/8 X 1-
3/4 bolts and two 3/8 locknuts.
21.
SECURELY assemble PULLEY to TOP BOOM
using one 3/8 X 2-3/4 bolt, one 3/8 locknut and
two 3/8 flange spacers. Create a loop with top
cable between pulleys and attach pulley plate
from step 18 to loop as shown on CABLE
ROUTING DIAGRAM.
22.
LOOSELY assemble five remaining PULLEYS
to the gym as shown on drawing.
23. Route CABLE 6575601 as shown in CABLE
ROUTING DIAGRAM and attach end to the
CROSS BRACE using one QUICK
DISCONNECT LINK.
22. Insert WEIGHT STACK SELECTOR PIN into
top WEIGHT PLATE.
23. SECURELY TIGHTEN ALL LOOSE PULLEY
CONNECTIONS AT THIS TIME.
24.
Connect top CABLE to SELECT SHAFT by
tightening the threaded end in until the cables are
taught.
25.
Attach one 3/8 X 2-3/4 bolt mid one 3/8 nut to
LEG CURL EXTENSION below the PULLEY
as shown on drawing.
26.
Insert the 15-3/4 TUBE into the LEG CURL
EXTENSION.
27. Attach ROLLER PADS and MUSHROOM
CAPS to the 15-3/4 TUBE and to ROLLER
PAD SWIVEL.
28. Attach four 1 x 8" GRIPS to LAT BAR and
LOW ROW BAR.
29. Attach LAT BAR and LOW ROW BAR to the
BOTTOM and TOP CABLES using three SNAP
LINKS and one CHAIN.
30.
The LAT BAR and LOW ROW EAR should be
disconnected from machine when performing
other exercises.
NOTE: CABLE MUST RUN’OVER TOP OF BOLTS[
LATBAR
CABLE (65’710 D 1
6587901
CABLE (6575601)
CABLE ROUTING DIAGRAM
6
-- LOW ROW BAR
03/01/96