Filter
Top Products
701
NOTE:
lO.
FACTOR 525 PEC DEC ATT. ASSEMBLY INSTRUCTIONS
(LEVEL
The D-RING CABLE CLIP on the end of the LINK CABLE should rcstjust above the D-RING. If the
LINK CABLE seems to be pulling on the D-RING or is resting too far above the D-RING, adjust it by
raising or lowering the two (2) 1/4-25 lN. NUTS that attaches the LINK CABLE to the PULLEY
BRACKET. When the correct height is obtained SECURELY tighten the two (2) 1/4-28 NUTS together
around the PULLEY BRACKET.
To adjust the pre-stretch on the PEC DEC AILVIS:
Pull up on the COT’fERLESS HITCH PIN.
Swivel the ARM forward or backward.
Let the PIN drop down into one ofthe two holes in the PEC ARM ADVANCES.
Or let the PIN drop behind the PEC ARM ADVANCES.
IF ASSEMBLING THE LEG PRESS ATTACHMENT NEXT, STOP HERE AND REFER TO
THOSE ASSEMBLY INSTRUCTIONS. IF ONLY ASSEMBLING TIIE PEC DEC ATTACHMENT
TO BASE UNIT, ~CONTINUE ON WITH THESE ASSEMBLY INSTRUCTIONS.
Wrap the SHROUD around the CABLES that t-oute to the D-RING, and assemble the SHROUD to
BOTH SIDES of the MIDDLE U,’~PRIGHT as shown in (VIEW F-F) on drawing, using the fourteen (14)
SHROUD FASTENERS.
THIS CONCLUDES THE ASSE~,IBLY OF (LEVEL 2), AND
THE ASSEMBLY OF THE PEC DEC ATTACHMENT FOR
THE FACTOR 525 BASE UNIT.