Filter
Top Products
~01
NOTE:
I0.
FACTOR 525 PEC DEC ATT. ASSEMBLY INSTRUCTIONS (LEVEL 1) ,--.
IF THE SHROUD IS ASSEMBLED TO THE FACTOR 525, IT WILL NEED TO BE REMOVED
TO ASSEMBLE THE PEC DEC A’vrACHMENT. PLEASE REMOVE THE SHROUD AT TH][S
TIME BY CAREFULLY REMOVING TIlE FOURTEEN (14) SHROUD FASTENERS.
Insert two (2) 2 IN. SQ. END CAPS into both ends of the BEARING HOUSING, as shown on drawing.
SECURELY assemble the BEARING HOUSING and the CENTER PULLEY BRACKET to the
FRONT UPRIGHT as shown on drawing, using two (2) I/2 X 4-I/2 IN. BOLTS, four (4) 1/2
WASHERS, and two (2) I/2 IN. LOCK NUTS. (THE CONNECTOR PLATES ON THE BEARING
HOUSING AND THE CENTER PULLEY BRACKET HAVE SLOTTED HOLES. SHIFT THE
BEARING HOUSING DOWN AND THE CENTER PULLEY BRACKET UP AS FAR AS
POSSIBLE)
Insert four (4) 2 IN. SQ. END CAPS into BOTH ENDS of the LEFT, and RIGHT PEC DEC ARMS
shown on drawing.
Assemble one (1) 314 IN: WASHER, and the LEFT ARM .ADVANCE to the LEFT PEC DEC ARM
shown on drawing. Also Assemble one (1) 3/4 IN. WASllEK, ".,qd the RIGHT ARM ADVANCE to the~
RIGHT PEC DEC ARM as shown.
Insert four (4) 3/4 IN. FLANGE BEARINGS into the BUSttlNGS of the BEARING ItOUSING,
shown on drawing.
Insert the LEFT and RIGHT PEC DEC ARMS through the 3/,4 IN. FLANGE BEARINGS in the
BEARING HOUSING on their respective sides as shown on dr’awing, ~d SECURE them in place with
two (2) 3/,4 I.D. STAR LOCK COL1.ARS.
Slide two (2) 4 X 12 ROLLER PADS onto the LEFT and RIGHT PEC DEC ARMS, until the
ROLLER PAD is FLUSH with the bottom of the ARMS. (IF A LUBRICANT IS REQUIRED, COAT
THE INSIDE OF THEROLI,ER PAl) WITll RUBIJINC ALCOIlOL. ALSO, ROTATING THE
PAD WHILE PUSHING UP WILL ilELP TO EASE ASSEMBLY)
Assemble two (2) KNOBS to two (2) COTTERLESS HITCH PINS as shown on drawing. Insert the
(2) COTTERLESS HITCH PINS through the BUSHINGS on th~ CAMS of the RIGHT and LEFT PEC
DEC AR51S, and into the holes on the PEC ARM ADVANCES. SEE DRAWING.
Attach two (2) CARRIAGE GUll)US ~o the CAB1 STOP o,i the BEARING ltOUSING where the
ARM ADVANCES makes contact with the CAM STOP.
LOOSELY assemble two (2) 4-1/2 X I IN. PULLEYS and two (2~ CABLE RETAINING CLIPS
CENTER PULLEY BRACKET as shown on dr-awing, using two (2) 3/8 X 2 IN. BOLTS, four (,~) 13/8
WASHERS, and two (2) 3/8 IN. LOCK NUTS. (NOTE: THIS CONNECTION WILL
TIGHTENED AFTER TI4E CABLE I tAS BEEN ROUrED)
THIS CONCLUDES THE ASSFMBLY OF (LEVEL 1)