Filter
Top Products
503 EXS00 PEC DEC ATTACHMENT ASSEMBLYINSTRU~’iONS
(STEP #1)
Attach eight ($) PARAGLIDE STRIPS to the BACK SUPPORT FRAME as shown in DETAIL on
(STEP #I SHEET #I of#2), using the following steps:
A. ThoroughIy clean all inside and outside surfaces where the PARAGLIDE STR/PS ~a’¢ to b¢
attached.
13.
14.
15.
B. Remove the paper backing from the PARAGLIDE STRIPS AND FIRMLY APPLY them to all of
the shown surfaces. (8 places)
Assemble the SPRING PIN ASSEMBLY on the BACK SUPPORT FRAME~ u~ing on(." (i) PLUNGER,
one (1) KNOB, one (I) SPRING, one (I) SPACER and one (1) COTTER PIN. (SEE
Insert the I-I/’2 IN. SQ. END CAP into the top end of the SPRING PIN ASSEMBLY FIOUSING on the
BACK SUPPORT FRAME. (SEE DETAIL A)
Securely assemble the BACK PAD, using two (2) 3."8 X 3 BOLTS, two (2) 3/8 LOCK WASHERS,
t~vo (2) 3/8 WASHERS.
16.
17.
18.
NOTE:
Insert one (I) 1-3:4 IN. SQ. END CAP into the end of the SEAT FRAME.
Disengage the SPRING PIN ASSEMBLY on the BACK SUI-PORT FRAME and insert the SEAT PAD
ASSEMBLY into the seat receptacle. Release the SPRING PIN and push the SEAT P.AD ASSEMBLY
down until the SPRING PIN PLUNGER ~ngages with the desired hole.
Securely assemble the SEAT PAD to the SEAT FRAME,.using ~,vo (2) 3/8 X 2-.3/4 BOLTS, ~vo (2)
LOCK WASHERS. and two (2) 3/8 WASHERS.
WHEN DESII~ED SEAT LOCATION IS FOUND, SECURE IN PLACE USING ONE
THUMBSCREW. (SEE DETAIL A)