Filter
Top Products
6
STEP 7
Install the NEW PRIMARY CABLE (13) using the following steps:
• Route the CABLE (13) back over one pulley in the GUIDE ROD SUPPORT, down through the PULLEY BRACKET (2) and over the
second pulley in the GUIDE ROD SUPPORT.
• Route the CABLE (13) around the FLOATING PULLEY BRACKET as shown in FIGURE 7.
• Route the CABLE (13) through the TOP BOOM as shown in FIGURE 7. The pulleys in TOP BOOM may need to be temporarily removed
to perform this step. (Note: Make sure the CABLE is running in all the pulley grooves.)
FIGURE 7
2
13
• Screw the threaded end of CABLE (13) into the HEAD PLATE ASSEMBLY.
IMPORTANT: Cable must run
in all the pulley grooves.
0
1
2
345
6
1/2 1/2 1/2 1/2 1/2 1/2