Filter
Top Products
13
BATTERY INSTALLATION
The Receiver Wrist Monitor uses a CR2032, 3V
Lithium battery. When the battery is running low the
low-battery indicator will light up. To guarantee the
water resistance take the monitor to a local jewelry
store for battery replacement. Improper replacement
will void the warranty.
The Transmitter uses a CR2032, 3V Lithium battery.
If the heart rate signals become unsteady or stop
your transmitter battery may need replacing.
To change the Transmitter battery:
1. Open the transmitter battery lid with a coin by
turning counterclockwise.
2. Remove the old battery.
3. Insert the new battery with the positive side
facing up. DO NOT touch the contacts.
4. Replace the battery lid.
CARING FOR YOUR MONITOR
To keep your heart rate monitor in the best condition
and protect the unit from damage follow these directions:
• Clean the monitor with a soft dry cloth. Do not use
any abrasive or volatile cleaners.
• Always thoroughly dry off any moisture on the
components before storing.
• Store your monitor in the original carrying case.
• Do not subject the monitor to extreme hot or cold
temperatures, humidity and direct sunlight.
• Do not excessively twist or bend the conductive
pads on the transmitter belt.
• Do not subject the transmitter or receiver to strong
shocks, such as dropping on the floor.
• Use the unit consistent with the instruction provided
in this manual.