Filter
Top Products
TO ADJUST THE CHRONOGRAPH HANDS:
1. If the chronograph hands currently show a
measured time, use button “B” to reset them near
the zero position.
Note that the hands must be stopped with button
“A” to allow button “B” to reset them.
2. Pull the crown out to the second click position (b).
3. Press button “A” and button “B” at the same time
and keep them pressed for at least two seconds.
This puts the chronograph in correction mode.
4. Press button “A” to adjust the chronograph hand
that measures seconds. Each press moves the hand
one short step; press and hold the button for
continuous movement.
5. Press button “B” then use button “A” to adjust the
chronograph hands that measure minutes and
hours. Each press of button “A” moves the minute
hand one short step; press and hold the button for
continuous movement.
6. Push the crown back down against the case.
AB
Button B
Button A
JUDGE INSTRUCTION MANUAL 05
ADJUSTING THE CHRONOGRAPH HANDS
When the chronograph is reset with button “B,” the three chronograph hands return to the zero position. If the
chronograph hands do not align precisely with the zero position (such as after a battery change), use the
following procedure to adjust them.
04 JUDGE INSTRUCTION MANUAL
USING THE CHRONOGRAPH
Button B
Button A
TO MEASURE A SECOND TIME TOTAL:
1. Press button “A” to start timing.
2. Use button “B” to pause the chronograph hands
as desired.
3. While the chronograph hands are moving, press
button “B” to display the first time total.
Although the chronograph hands are no longer
moving, time is still being measured.
4. Press button “A” when you reach the moment for
marking the second finishing time, then press
button “B” to display the second time total.
5. Press button “B” to reset the chronograph hands to
the zero position.
04-00774_Judge Manual 2/2/05 3:50 PM Page 6