Filter
Top Products
9
6. Raise the Frame (55) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Latch Assembly (76) so that the large
barrel and the Latch Knob (50) are in the posi-
tions shown.
Attach the Latch Assembly (76) to the Uprights
(85) with a 3/8" x 2" Bolt (109) and a 3/8" Nut
(20).
Attach the upper end of the Latch Assembly (76)
to the bracket on the Frame (55) with a 3/8" x 2"
Bolt (109) and a 3/8" Nut (20). Note: It may be
necessary to move the Frame back and forth to
align the Latch Assembly with the bracket.
Lower the Frame (55) (see HOW TO LOWER
THE TREADMILL FOR USE on page 28).
76
20
20
Large
Barrel
85
109
55
6
109
50
7. Identify the Left Base Cover (88), which has
cutouts in the locations shown. Slide the Left
Base Cover onto the left Upright (85). Then, slide
the Right Base Cover (86) onto the right Upright.
Identify the Left Upright Sleeve (77) and the
Right Upright
Sleeve
(9). Slide the Upright
Sleeves onto the Uprights (85) as shown.
88
77
86
9
85
Cutouts
7
5. Identify the Latch Assembly (76). Remove the
t
ie from the end of the tube. Make sure that the
sleeve has been slid over the indicated hole and
that the Latch Knob (50) is locked into the hole.
Pull on the sleeve to make sure that it is
l
ocked into place.
5
50
Sleeve
H
ole
Tube
76