Filter
Top Products
31
b. If the walking belt slips when walked on, first remove
the key and UNPLUG THE POWER CORD. Using
t
he hex key, turn both rear roller bolts clockwise, 1/4
of a turn. When the walking belt is correctly tightened,
y
ou should be able to lift each edge of the walking
belt 3 to 4 in. (8 to 10 cm) off the walking platform. Be
careful to keep the walking belt centered. Then, plug
in the power cord, insert the key, and carefully walk
on the treadmill for a few minutes. Repeat until the
walking belt is properly tightened.
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION:
a. With the key in the console, press one of the Incline buttons. While the incline is changing, re-
move the key.
After a few seconds, re-insert the key. The treadmill will automatically rise to the
maximum incline level and then return to the minimum level. This will recalibrate the incline system.
PROBLEM: Television reception is poor
SOLUTION: a. Check for the problems listed below and follow the applicable instructions.
• Ignition (black spots or horizontal streaks that appear or a picture that flutters or drifts)—Usually
this is caused by interference from automobile ignition systems, neon lamps, electric drifts, or
other electric appliances. Try changing the position of other electric appliances to correct the
problem. The treadmill should be plugged into its own electrical circuit.
• Ghosts—Ghosts are caused by the television signal following two paths—one is the direct path
and the other is reflected from tall buildings, hills, or other objects.
• Blue Screen—If the cable channel signal is weak, the picture may be of poor quality or a blue
screen may appear.
Note: If one of these symptoms appears when the cable from a CATV company is connected, the
symptom may be caused by the local cable company signal reception.
PROBLEM: While using an iFIT card, you cannot hear the voice of the personal trainer
SOLUTION: a. If you cannot hear the personal trainer’s voice while using a program on an iFIT Card, the AUDIO
TRAINER: OFF setting is selected. See step 1 on page 25 and select the AUDIO TRAINER: ALL or
AUDIO TRAINER: ON setting.
b