Filter
Top Products
1
1
12 With the help of a second person, carefully
lower the Uprights (85) to the position shown.
Attach the Right Base Cover (86) with three #8 x
3/4" Screws (7) and two Base Cover Screws
(63).
Start all five Screws and then tighten
them. Be careful not to overtighten the
Screws. Attach the Left Base Cover (88) in the
same way.
With the help of a second person, carefully raise
the Uprights (85) to the vertical position.
14. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key
in a secure place. The hex key is used to adjust the walking belt (see page 30). To protect the floor or car
-
pet from damage, place a mat under the treadmill.
63
7
88
86
63
7
85
12
13. Note the location of the 75 ohm terminal on the
treadmill. For the television to operate, an
audio/video wire must be connected to the
audio/video input jack on the back of the con-
sole, a personal audio/video player must be con-
nected to the audio/video plug on the console, or
a CATV cable must be connected to the 75 ohm
terminal (see page 13).
13
75 Ohm
Terminal
11. See drawing 11a. Remove the indicated #8 x
3/4" Screw (7) from the right Handrail (70).
See drawing 11b. Slide the Right Upright
S
leeve (9) up to the console assembly. Attach
the Right Upright Sleeve with two #8 x 1" Tek
Screws (82) and the #8 x 3/4" Screw (7) as
shown.
Attach the Left Upright Sleeve (not shown) in the
same way.
9
7
7
70
82
Console
Assembly
11a
11b