Filter
Top Products
8
10. Wrap the Cable (133) under a 4” Pulley (113) and
attach the Pulley and a Cable Trap (116) to the Base
Frame (101) with a 3/8” x 3 3/4” Bolt (110), a 3/8”
Washer (120), and a 3/8” Nylon Locknut (118). Make
sure the Cable is routed in the direction shown.
11.Insert the end of the Cable (133) between the 4”
Pulley (113) and the Cable Trap (116) assembled in
step one.
9. Wrap the Cable (133) up around a 4” Pulley (113) and
attach the Pulley and a Cable Trap (116) to the Rear
Press Upright (104) with a 3/8” x 3 3/4” Bolt (110), a
3/8” Washer (120), and a 3/8” Nylon Locknut (118).
Make sure the Cable is routed in the direction
shown.
9
120
116
104
113
133
118
10
116
101
133
120
110
118
11
133
113
116
8. Open the parts bag labeled “CABLE ASSEMBLY.”
Attach the Cable (133) to the indicated hole in the
Press Base (101) with a 3/8” x 3” Bolt (117), two 3/8”
Washers (120), a 5/8” x 1/4” Spacer (127), and a 3/8”
Nylon Jam Nut (122). Do not over tighten the Nylon
Jam Nut; the Cable must be able to pivot easily.
8
120
120
133
127
101
122
117
Cable Assembly
110
113