Filter
Top Products
5. Remove the knob from the pin. Make sure that the collar
a
nd the spring are on the pin.
P
ress the Latch Insert (77) into the right side of the left
Upright (85), and press the Knob Insert (92) into the left
side of the left Upright. Use a rubber mallet, if necessary.
Next, insert the pin into the Latch Insert, and tighten the
knob back onto the pin.
77
92
5
K
nob
85
Pin
Collar
Spring
6. Place the treadmill in the storage position (see HOW TO
FOLD AND MOVE THE TREADMILL on page 27).
Hold the cylinder end of the Shock (114) near the
bracket in the center of the crossbar on the Frame (55).
See the two small inset drawings. Using your fingernail
or the end of a screwdriver, press on the end of the
Shock Pin (108) to loosen it from the Shock (114). Next,
rotate the Shock Pin and pull it out of the Shock.
Be
careful to avoid losing the Shock Pin.
Orient the Shock (114) so it is in the position shown.
Press the end of the Shock onto the ball on the bracket.
See drawing 6a. Insert the Shock Pin (108) into the two
indicated small holes in the end of the Shock (114).
Then, rotate the Shock Pin until it clips onto the Shock.
Note: Extra Shock Pins are included.
108
55
114
Hole
Hole
108
114
6a
Bracket
Cylinder
Bracket
108
108
6
8