Filter
Top Products
10
7. Slide the Right Upright Sleeve (96) up against
the console assembly. Attach the Right Upright
Sleeve with two #8 x 3/4" Tek Screws (29).
Attach the Left Upright Sleeve (not shown) to
t
he console assembly in the same way.
2
9
96
29
7
C
onsole
A
ssembly
8. Orient the Storage Latch (100) so that the large
barrel and the Latch Knob (118) are in the posi-
tions shown.
Remove the tie from the upper end of the
Storage Latch (100). Attach the upper end of the
Storage Latch to the bracket on the Frame (48)
with a 3/8" x 1 3/4" Bolt (117) and a 3/8" Nut
(38).
Remove the tie from the lower end of the
Storage Latch (100). Keep the holes in the
Latch Cap (119) aligned with the holes in the
Storage Latch. Make sure to keep the Latch
Cap inside the Storage Latch. Attach the
Storage Latch to the bracket on the Base (83)
with a 3/8" x 2" Bolt (113) and a 3/8" Nut (38).
Note: It may be necessary to move the Frame
back and forth to align the Storage Latch with
the bracket.
Lower the Frame (48) (see HOW TO LOWER
THE TREADMILL FOR USE on page 30).
38
38
Large
Barrel
83
119
113
48
117
118
100
8