Filter
Top Products
32
8
6. Attach the Seat (5) to the Seat Frame (6) with
four M6 x 16mm Screws (38).
7. Press two 40mm x 60mm Inner Caps (46) into
the Leg Lever (8). Press two 60mm Round
Bushings (18) into the Leg Lever. Press a 48mm
Round Inner Cap (19) into the weight tube. Slide
the Weight Tube Spacer (20) onto the weight
tube. Make sure the slot fits around the Leg
Lever.
8. Attach a set of Pads (16, 44) to a Pad Brace (17)
with four M6 x 16mm Screws (38). Make sure
the Pads and the Pad Brace are oriented as
shown. Repeat with the other set of Pads and
the other Pad Brace.
Attach a Pad Brace (17) to the Leg Lever (8) with
two M10 x 80mm Carriage Bolts (39), two M10
Washers (33), and two M10 Nylon Locknuts (32).
Attach the other Pad Brace to the Leg Lever
(8) in the same manner.
9. Press the 50mm Square Outer Cap (21) onto the
Seat Extension (13). Press the 50mm Square
Bushing (22) into the Seat Extension. Make sure
the tabs on the Bushing snap into the slots in
the Extension.
Lubricate an M12 x 77mm Button Head Bolt (36)
with grease. Attach the Leg Lever (8) to the Seat
Extension (13) with the Bolt and an M12 Nylon
Locknut (47). Do not overtighten the Locknut;
the Leg Lever must be able to pivot easily.
6
38
38
5
6
7
8
9
8
18
18
46
46
20
19
Slot
Weight
Tube
39
8
44
16
17
38
39
17
33
32
22
Tab
Slot
33
13
47
36
21
8
38
Straight
Edge
Straight
Edge