Filter
Top Products
ASSEMBLY
A
ssembly requires two persons.
S
et the treadmill in a cleared area and remove all packing materials.
D
o not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex key and your own phillips screwdriver , wire
cutters , and rubber mallet . For help identifying the assembly hardware, see the
hardware drawings below.
6
w
(123)–2
1
/2” Silver Screw
(48)–1
3
3
/4” Tek Screw (58)–4
3
Spacer Screw (60)–2
1
1” Screw (148)–4
Console Bolt (78)–2
3
Pulse Bar Bolt (33)–4
Star Washer (77)–8
Short Console
Bolt (106)–2
Nut (9)–2
Wheel Bolt (94)–2
P
Extension Leg
Bolt (130)–4
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the
treadmill onto its left side as shown. Partially fold the
Frame (110) so the treadmill is more stable.
Do not fully
fold the treadmill until it is completely assembled.
Insert the two Extension Legs (102) into the base of the
Uprights (69); make sure that the Extension Legs are
turned so the Base Pads (99) are in the positions shown.
Attach each
Extension Leg (102) with two Extension Leg
Bolts (130).
102
99
130
110
130
99
102
69
1