Filter
Top Products
9
5
. Pivot the piston end of the Gas Spring (88) downward.
Remove the Spring Pin (102) from the end of the Gas
Spring.
N
ext, hold the end of the Gas Spring (88) near the indi-
cated bracket on the Base (83). Press the end of the Gas
Spring as far as possible onto the ball on the bracket. If
necessary, pivot the Frame (48) slightly and rotate the
Gas Spring to align the end of the Gas Spring with the
ball on the bracket. See the inset drawing. Insert the
Spring Pin (102) into two of the small holes in the end of
the Gas Spring, and rotate the Spring Pin until it clips
onto the Gas Spring.
With the help of a second person, lower the Frame (48)
back to the floor.
8
8
102
5
8
3
48
B
racket
6. Remove the elastic bands securing the Upright Wire
Harness (75) and the TV Cable (110). Next, insert the
Upright Wire Harness and the TV Cable through the
Handrail Spacers (95) as shown, and press the Handrail
Spacers into the tops of the Uprights (73, 74).
Have two persons hold the console assembly near the
Uprights (73, 74). Connect the Upright Wire Harness (75)
to the wire harness on the console assembly.
Make sure
to connect the connectors properly (see the inset
drawing); the connectors should slide together eas-
ily and snap into place. If the connectors do not slide
together easily and snap into place, turn one connector
and try again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON.
Next, connect the TV Cable (110) to the cable on the left
side of the console assembly.
Insert the Upright Wire Harness (75) and the TV Cable
(110) down into the Uprights (73, 74). Next, insert the
brackets on the console assembly into the Uprights. Be
careful not to pinch the wires.
Console
Assembly
Cable
73
Console
Wire
95
75
74
6
95
110
7. Finger tighten three Handrail Bolts (64), with three
Handrail Star Washers (90), into the Right Upright (74)
and the console assembly. Repeat this step with the Left
Upright (73). After all six Handrail Bolts have been
started, tighten the four front Handrail Bolts first,
and then tighten the other two Handrail Bolts.
7
Console
Assembly
90
64
90
73
74
64
75
102
88
Bracket