Filter
Top Products
7
ASSEMBLY
A
ssembly requires two persons.
S
et the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included allen wrench and your own phillips screwdriver . To
avoid damaging plastic parts, do not use power tools for assembly.
For help identifying assembly hardware, see the drawings below. Note: If a part is not found in the part bags,
check to see if the part has been preattached.
1. Identify the Right Upright (74), which is marked with a
sticker. Place the Right Upright near the right side of the
treadmill. Next, identify the lower end of the Right
Upright, which has three small holes. Feed the Upright
Wire Harness (75) into the lower end of the Right Upright
and out of the upper end as shown.
See the inset drawing. Place the Left Upright (73) near
the left side of the treadmill. Feed the TV Cable (110)
into the lower end of the Left Upright and out of the
upper end as shown.
Stretch the included elastic bands around the upper ends
of the Uprights (73, 74) to hold the TV Cable (110) and
the Upright Wire Harness (75). Do not remove the elas-
tic bands until you begin step 6.
Handrail Star
Washer (90)–6
Upright Bolt (72)–6
3/4” Screw (4)–2
Upright Star
Washer (71)–6
Washer (78)–6
1
Handrail Bolt (64)–6
5
75
74
73
110
Band
Band
Small
Holes
1