Filter
Top Products
ASSEMBLY
A
ssembly requires two persons.
S
et the treadmill in a cleared area and remove all packing materials.
D
o not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench and your own phillips screwdriver ,
adjustable wrench , and rubber mallet . For help identifying the assembly hard-
ware, see the drawings below.
The number in parentheses below each drawing is the key number of the part,
from the PART LIST on pages 30 and 31. The number following the parentheses is the quantity needed for assem-
bly. Note: Some small parts may have been pre-assembled. If a part is not in the parts bag, check to see if
it has been pre-assembled.
6
1” Tek Screw (82)–4
Washer (96)–8
Console Bolt (72)–4
3
Extension Leg Bolt (87)–4
Star Washer (67)–4
Nut (106)–4
Plastic Spacer
(115)–4
1. With the help of a second person, carefully raise the
Uprights (85) to the vertical position. Remove the band
securing the Upright Wire Harness (73) to the right
Upright.
Have a second person hold the console assembly
near the right Upright.
Connect the Upright Wire Harness (73) to the wires extend-
ing from the console assembly.
Make sure to connect the
connectors properly (see the inset drawing). The con-
nectors should slide together easily and snap into
place. If the connectors do not slide together easily and
snap into place, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON. Insert the connectors into
the
right Upright (85).
73
85
Console
Assembly
73
1