Filter
Top Products
11
9. Set the console assembly face down on a soft
surface to avoid scratching the console.
I
dentify the Right Handrail (79). Hold the Right
Handrail near the console assembly. Route the
c
onsole wire through the large holes in the top
and bottom of the Right Handrail.
Set the Right Handrail (79) on the Console
Frame (81). Start a 1/4" x 1/2" Patch Bolt (8)
with a 1/4" Star Washer (12) into the Right
Handrail. Then, start two 5/16" x 1 1/2" Patch
Bolts (4) with two 5/16" Star Washers (9) into
the Right Handrail. Make sure the console
wire is not pinched. Start all three Patch
Bolts, and then tighten them.
Attach the Left Handrail (not shown) as de-
scribed above. Note: There is not a wire on
the left side.
79
Console
Assembly
4
8
12
9
81
9
Console
Wire
10. With the help of a second person, hold the con-
sole assembly near the Right Upright (83) and
the Left Upright (not shown).
Connect the Upright Wire (85) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Remove the wire tie from the
Upright Wire.
Console
Assembly
10
Console
Wire
Wire
Tie
85
83
85
Console
Wire