Filter
Top Products
17
Manually Calibrate the SDM Pod
After calibration, the SDM pod automatically
calculates an offset value. The default value is 1000.
Change the offset value to make small adjustments to
the calibration. If the SDM pod is slightly under measuring
a known distance, increase the offset value. Different shoe
models may affect the pod calibration. Adjust the offset value
accordingly if you notice differences between shoes.
Follow steps through to fine-tune the offset value.
7
8
3 SEC
2
5
3
4
If you ran 800 meters, adjust displayed
distance to read 800m.
Press several
times to scroll
to OFFSET.
EXIT
Scroll to
WKOUT or
CHRON mode.
EXAMPLES
1000 = factory setting
990 = 99% of factory setting
1010 = 101% of factory setting
The offset value is 1000. You run
400m. The SDM pod returns a
reading of 380m (5% under)
The offset value should be
adjusted to 1050 (5% above).
NOTE: Write down and save your
offset value. It will come in handy
if you let friends or family borrow the
Triax Elite system and they change the
calibration setting.
Press to change value.
EXIT