Filter
Top Products
20
Data Recall mode
In Data Recall mode results of the last 10 measurements
can be displayed.
Measurement results are saved in on-board memory in
sets depending on the parameters set for measuring, for
instance, if only distance is measured - the set will consist
of one number, if distance and azimuth are measured –
the set will consist of two numbers.
To enter Data Recall mode select rEc from the main
menu. First measurement set number (display name: rEc
1) will start flashing.
Pressing M button moves the unit along the list of
measurement set numbers and measurement results:
rEc 1, distance 1, azimuth 1, elevation 1,
rEc 2, distance 2, azimuth 2, elevation 1, …,
rEc 0, distance 0, azimuth 0, elevation 0.
Measurement sets are numbered in reverse order: first
recalled set is the result of the last measurement. If any
parameter has not been actually measured it will not be
recalled.
Pressing A button at any moment within the list of
recalled results brings the unit to Ready to Measure mode.
Choosing cLr at the end of recalled data will erase the
device memory.