Filter
Top Products
11
Using the Device
The LRB 6000CI operational procedures are design to
allow the user to use most applicable options in the fastest
time possible. To activate it, press and hold Action button
(6, Fig.1) for one second. At start the unit comes into
Ready to Measure mode indicated by the word ‘READY’
on the display visible through the eyepiece.
Pressing Action button (6, Fig. 1) again will initiate
measurement procedure. The results of measurement are
displayed in default form of “Distance (M), Azimuth
(mils) and Elevation (mils)” measurement parameters also
can be modified to user preference (see Setup Mode).
If results of measurement are unreliable four dashes
(‘----‘) will be displayed in the area (4, Fig. 3).
Pressing Mode button (5, Fig. 1) gives the user the
options to change settings from Factory default to specific
modes required by user. For full list of Mode options
please refer to Operation and Service modes
If the target is located below the unit the result of vertical
measurement (elevation or height) will be preceded with
minus (“-“) sign.