Filter
Top Products
STEP 1 - Upright Assembly
a) Stand on Walking Belt and grip the
uprights and slowly raise them into
the assembled position. Secure the
right side with (2) M8 x 20mm Allen
Bolts (1) M8 Washer and (1) M8
Curved Washer at the bottom of the
right Upright as shown in Figure 1.
Repeat on other side.
b) Use the Allen Wrench provided to
tighten.
STEP 2 - Console Base Assembly
Note: To assure Console Base Assembly does
not fall, hold onto Hand Grips while assembling.
a) Make sure the wires are connected on the
right side. See Figure 2a.
b) While standing on the Walking Belt put the
Console Base Assembly in the user position by
pivoting it carefully down. See Figure 2b.
Note: During assembly, DO NOT PINCH WIRES
when the Console is folded down and
secured to the Upright.
c) Attach the Console Base Assembly
to the Uprights by using an
M8 x 20mm Allen Bolt and
M8 Curved Washer.
Repeat on other side.
Tighten with Allen Wrench
provided. See Figure 2c.
2b
2c
upright
RIGHT SIDE
M8 curved
washer
Figure 1 - Install Uprights
Figure 2 - Install Console Base
M8 x 20mm
allen bolt
M8 washer
M8 x 20mm allen bolt
M8 curved
washer
walking belt
console base
assembly
upright
hand
grip
Note: We recommend setting up the
unit in the area where it will be used.
Remove Box Top. Collapse Box Bottom
and leave unit in box to assemble.
7
2a