Filter
Top Products
13
turn clockwise.Turn on the Treadmill and check the
tension. If it needs additional tension, continue to
tighten one turn at a time until the Belt is no
longer slipping.
Be sure to adjust both sides equally to insure correct
Belt alignment.
WALKING BELT CENTERING
The Walking Belt may
occasionally need to be
centered.Your Treadmill
has sight indexes that aid in
keeping the Walking Belt
centered.
First, be sure the Belt is
tensioned properly. Then,
run the Treadmill at 4 mph.
It is easiest to use only the
left Adjustment Knob in
making Walking Belt center-
ing adjustments.
If the Walking Belt has moved to the right, turn the Left
Adjustment Knob a quarter turn to the left. Let the
Treadmill run about 30 seconds,
and if the Belt
does not move,
repeat.
If the Walking Belt has moved to the left, turn the Left
Adjustment Knob a quarter turn to the right. Let the
Treadmill run about 30 seconds, and if the Belt does
not move, repeat.
WARNING: Always turn off and unplug the Treadmill
from the electrical outlet before moving, cleaning,
lubricating, or servicing the Treadmill.
Note: The Treadmill MUST be placed on a level
surface only. If the Treadmill is not level, the belt
will continuously slip to the low side of the Treadmill.
CAUTION: DO NOT USE Treadmill if it is not on a
level surface.
Have plenty of clearance behind and in front of
your Treadmill. It is important to keep children,
pets, furniture and other objects out of the way
when using your Treadmill. You should have a
minimum of 4 feet of clearance both in front of and
behind your Treadmill and a minimum of 2 feet of
clearance on both sides of the Treadmill.
Worn or damaged components should be replaced
immediately. Do not use the Treadmill if it is not
working properly. Only manufactured-supplied or
approved components shall be used to maintain
and repair the Treadmill. It is the sole responsibility
of the user/owner to ensure that regular mainte-
nance is performed.
WALKING BELT TENSION
Walking Belts tend to stretch slightly with use. The
Walking Belt may occasionally need to be tight-
ened. If the Walking Belt is too loose, you may find
the Belt stops or hesitates while running or walking.
However, it is very important not to over-tighten the
Walking Belt as it will damage the Motor, Rollers,
and Electrical Components.
When properly tensioned, you should be able to
lift the side of the Belt about 2-3 inches, or you
should be able to fit three fingers under the edge
of the Belt. This should be done on either side of
the Belt in the center of the Deck.
To tighten the Belt, with the Treadmill off, turn the
Left Knob at the end of the Treadmill one full turn
clockwise, and then turn the Right Knob one full
belt
foot rail
sight index
(preset at 2)
TAKING CARE OF YOUR TREADMILL