Filter
Top Products
Belt Lubrication
Use only 100% Silicone and avoid using aerosol silicone sprays which include additives and petroleum
The running belt should be lubricated every 3 months (regardless of use) or every 50
over time and the belt will dry out.
Note: Even though the running belt is lubed from the manufacturer, you should lubricate
the unit was manufactured and when it was purchased.
The Silicone icon will turn on in the display every 100 hours of use and is a reminder that it is time to
lubricate the running belt. As indicated above it is best to lubricate the running belt every 50 hours of use.
Apply the silicone to the underside of the treadmill belt. Do not apply to the walking surface.
This may be accomplished by standing up the treadmill and applying the silicone to the inside portion
Note: When lubricating the belt, make sure the treadmill is located on a surface that can be easily
Cleaning and Maintenance
It is recommended to wipe the treadmill down after each use to keep the treadmill clean and dry. A
mild detergent may be used at times to help remove all dirt and salt from the belt, painted parts and
the display.
The Maintenance icon shows up in the display every 150 hours of use. This is a reminder to clean the
unit really well. This cleaning would include removing the motor cover and cleaning around the
motor and electronics. It is recommended to clean the motor compartment if the treadmill is in an
motor compartment. It is a good idea at this time to check and tighten all assembly hardware as well.
Warning: Unplug the Power Cord Before Removing the Motor Cover.
of the belt. Spray the silicone down and across the belt. Rotate the belt 1/2 of the circumference
and repeat. About one ounce of Silicone should be used for each application.
30