Filter
Top Products
7
Toll Free LifeSource Health Line 1-888-726-9966
GETTING STARTED
1. In dry and cold climates it may take a few minutes of use for the electrodes to soften and a layer
of perspiration to form between the contact and the skin for good performance. Moistening the elec-
trodes with saliva or conductive gel can speed up this process.
2.
To ensure the most accurate operation we recommend wearing the chest transmitter against your
bare skin.
Users with a lot of chest hair may have a problem getting contact between the
transmitter electrode areas and their skin, resulting in poor performance. Because of this it may
be necessary for these individuals to shave the area of their chest beneath the transmitter.
3.
Do not use water, moisturizing creams or suntan oil, as these are insulators and will inter-
fere with the heart rate signal.
4. Wear the wrist receiver as you would any
wrist watch. Keep the wrist receiver and the
transmitter within 3 feet/1 meter of each
other. You can also attach the wrist receiver
to the bike handlebar bracket included in the
package.
3. Adjust the strap so the transmitter fits tightly
below the pectoral muscles with the
LifeSource logo centered on the sternum as
shown in the picture.
2. Moisten the electrode areas —located to
the right and left on the back side of the
transmitter —with saliva or conductive gel.
6
Toll Free LifeSource Health Line 1-888-726-9966
GETTING STARTED
WEARING THE TRANSMITTER BELT
To ensure a proper heart rate detection, the chest transmitter must be moistened and
properly fitted.
Electrode areas
1. Snap the plastic tabs at the end of the
adjustable strap into the holes at the end of
the transmitter.