Filter
Top Products
Sport and Essential Consumer Treadmills
Incline Motor/Motor Controller Replacement
2
HOW TO…REPLACE THE INCLINE MOTOR OR MOTOR CONTROLLER -
CONTINUED
7. Remove the black and white
wires from the unit’s AC
connector. Leave the green
ground wire attached.
8. Disconnect the incline motor’s
black and white wires from the
motor controller. Leave the red
ground wire attached.
9. Connect these two incline-motor
wires to the black and white
connections at the bottom
position fast-ons of the AC
connector.
10. Plug the line cord into the wall
outlet. The unit will raise
automatically and stop at its
maximum (10%) incline.
11. Unplug the line cord.
If the incline motor is being replaced,
proceed to step 12. If only the motor
controller is being replaced, skip to step 24.