Filter
Top Products
1.2 SETUP
Read the entire Operation Manual before setting up the Lifecycle exercise bike.
WHERE TO PLACE THE LIFECYCLE EXERCISE BIKE
Following all safety instructions in Section 1.1, move the bike to the location in which it will be used. See Section 7, titled
Specifications, for the dimensions of the footprint. Allow a distance of 16 inches, or 41 centimeters, between the widest
part of the bike and other objects on either side. Allow a distance of 3 feet, or 1 meter, between the front or rear of the bike
to any other objects.
HOW TO STABILIZE THE LIFECYCLE EXERCISE BIKE
After placing the bike in position, check the unit’s stability by attempting to rock it from side to side. Any slight rocking indi-
cates that the unit must be leveled. Determine which foot is not resting completely on the floor. Loosen the jam nut (A)
with an open-end 9/16-inch wrench, and rotate the stabilizing foot (B) to lower it. Verify that the bike is stable, and repeat
the adjustment as necessary until the unit no longer rocks. Lock the adjustment by tightening the jam nut against the sta-
bilizer bar.
HOW TO ADJUST THE SEAT
A properly adjusted seat is extremely important in any bike-oriented exercise activity and the Recumbent Lifecycle Exer-
cise Bike is no exception. If the seat is too close, excessive strain will be placed on the knees and quadriceps muscles; if
the seat is too far, the resulting reaching action will irritate the feet, ankles, hips and knees.
Sit on the seat and place the balls of the feet on the pedals. An optimum position will allow movement through the bottom
of the stroke without locking the knees or shifting in the seat. The knees should have a slight bend at the point of fullest
leg extension.
If the seat needs to be adjusted, lift the spring-loaded adjusting han-
dle located on the right, front side of the seat. Slide the seat forward
or backward as necessary to the proper position and release the han-
dle to complete engagement. Gently slide the seat forward and back-
ward a small distance to ensure it is locked into place. Check the seat
distance again and re-adjust it if necessary.
CAUTION: Do not attempt to adjust the seat while pedaling
the bike. Doing so, or failing to engage the seat handle may
result in an uncomfortable workout or cause injury.
MISE EN GARDE : Ne pas essayer d'ajuster la selle pen-
dant le pédalage. Tout ajustage en cours de fonctionnement
ou toute insertion incomplète de la goupille de la selle pour-
rait nuire à l'exercice ou entraîner des blessures.
B
A
7