Filter
Top Products
MUST DISASSEMBLE ONE END OF CABLE AND REASSEMBLE AFTER ROUTING (SEE FIG 7 PAGE 14)
STEP 4
NOTE: IF THE 50# ADD ON KIT WAS PURCHASED, USE THE CABLE FROM THAT KIT AND REFER TO
KIT ASSEMBLY INSTRUCTION FOR HEAD PLATE ASSEMBLY
Dimension between bottom of PULLEY BRACKET and top of JAM NUT approximately 1 inch.
Taking one end of UPPER (SHORT) CABLE 7745402 (43) insert thru top front pulley and follow routing illustration to
HEAD PLATE PULLEY (10) and continue to other side ending at the other top front pulley.
CABLE MUST BE INSERTED BETWEEN PULLEY AND CABLE RETAINING CLIPS AND MOVE FREELY
11
FIGURE 4
EYE HOOK ORIENTATION
NOTE: SHROUDS HAVE BEEN REMOVED FOR ILLUSTRATIONAL PURPOSES ONLY
LEA7745402
LEA