Filter
Top Products
STEP 7
Plug cables into the back of display console:
1. Plug the 10-pin connector at the end of the upper wire
harness into the 10-pin connector (10P) in the back of the
display console (K). Make sure the connector snaps into
place.
2. Plug the 3-pin connector at the end of the heart rate cable
into the 3-pin (3P) connector in the back of the display
console (K). Make sure the connector snaps into place.
3. Plug in flat 6 pin (6P) connector for the Activity Zone.
4. Push excess cable(s) into the opening of the upright tube
assembly (A).
5. Plug the spade connector attached to the console plate
(J) into the connector (GR) leading from the back of the
display console (K)
15